Electronic Volumeter with integrated volume corrector TME 400-VC
For the process: The integrated one for in-house measurements
A new class of instruments has been created with the TME400-VC series:
Sensors for pressure and temperature of the sample gas are integrated in the measuring unit and electronic counter. Volume and flow rate can then be calculated from these measured values, even under standard conditions. For conversion methods, you can choose between GERG88, AGA 8 Gross Methods, AGA 8 NX19 and GOST30319.
All measured and calculated values can be displayed and are available on the Modbus interface. For control purposes, a measured value can also be output in analog form. As with the TME400-VM, parameterization, e.g. entering the gas composition values for conversion, is preferably carried out via the RMGViewTME software. This series is also battery-powered.
Sensors for pressure and temperature of the sample gas are integrated in the measuring unit and electronic counter. Volume and flow rate can then be calculated from these measured values, even under standard conditions. For conversion methods, you can choose between GERG88, AGA 8 Gross Methods, AGA 8 NX19 and GOST30319.
All measured and calculated values can be displayed and are available on the Modbus interface. For control purposes, a measured value can also be output in analog form. As with the TME400-VM, parameterization, e.g. entering the gas composition values for conversion, is preferably carried out via the RMGViewTME software. This series is also battery-powered.
Device for measuring volume and flow rate in operating and standard condition
- Turbine meter with electronic totalizer and integrated volume corrector
- Short design
- Integrated temperature and pressure measurement
- Simple and inexpensive assembly, as installation work for pressure and temperature measurement is not required
- Display of pressure, temperature, volume and flow rate, each in operating and standard status
- Battery operation (6 years), external supply optional
- Serial interface (Modbus)
- Current output optional (with external supply), optionally for flow rate, pressure or temperature
- Very good reproducibility
- Durable, low maintenance and robust
- Horizontal or vertical mounting position possible
- Electronic linearization of the error curve (with external supply)
- Special versions for corrosive gases (e.g. raw biogas)
- Operation / parameter setting via the RMGViewTME diagnostic software
- DIN-DVGW tested
Technical Product Information & Software
TME 400 VM/VC-EN
Data sheet, pdf (766kb)
EU-DoC_TME400VM TME400VC_2022-12-20
Declaration of Conformity, pdf (178kb)
RMGViewTME_V3_0_2_2022-09-07
Software, zip 4mb, password: RMG
Operating instructions
TME 400 VC-EN
Operating instructions, PDF (8.0mb)
If you have any questions:
Electronic Volumeter with Integrated Volume Corrector TME 400-VC
Please contact us if you have any questions or need help. Our employees are always there for you.